How to Measure a Window Seat Cushion for Replacement Foam
A window seat may look rectangular, but the space between its side walls, the window frame and the front edge is not always square. Before ordering a foam insert, measure the finished seating area and decide whether you are replacing an existing cushion or making one from scratch.
Start with the seat, not the old foam
Take three measurements in centimetres: the usable length from side to side, the depth from the back to the front edge, and the thickness you want the finished cushion to have. Write them as length x depth x thickness. For example, 120 x 45 x 8 cm describes one cushion, not three separate pieces.
If the seat sits between walls or cupboards, measure the length at the front and the back. Measure the depth at both ends as well. A small difference can matter when a foam insert must fit a recess. Do not assume the old insert is an exact template: used foam can be compressed or distorted.
Check for corners and obstructions
Look for angled side walls, a projecting window sill, radiator pipes, hinges or a lid that needs to open. Draw a simple top-down sketch and mark each measurement on the corresponding edge. If the back corners are cut away or the front edge is curved, add a clear photo of the seat and sketch the shape; a single length and depth cannot describe every cut.
For a storage bench, leave enough clearance for the lid to lift. Check the height of any handles, armrests or nearby window fittings before choosing thickness. The most comfortable thickness depends on the seat and how it will be used, so avoid copying another cushion's specification without checking the available space.
Replacing an existing covered cushion
If the removable cover still fits the bench well, measure its finished length and depth while it is laid flat without stretching it. Measure the side border for thickness. Note any taper or rounded corners separately. If the old foam is worn, compare it with the cover rather than relying on its flattened thickness.
If you plan to reuse a close-fitting cover, tell Right Foam. The cover's construction affects the finished fit, and an insert that looks correct against the bare seat may be too large for the cover. Right Foam supplies foam inserts, not fabric covers.
One long cushion or several pieces?
Record the quantity and dimensions of each piece separately. A long seat might need one continuous insert or two or three sections so the covers can be removed and handled individually. If there are seams in existing covers, match your measurement list to those seams. For example: piece 1, 60 x 45 x 8 cm, quantity 2. That is clearer than simply requesting 120 cm of foam.
Before you request a price
Send the length, depth, thickness, quantity and a sketch for any non-rectangular shape. State whether the cushion is for everyday seating and whether you already have a cover. For straightforward rectangular pieces, you can enter the measurements into Right Foam's instant quote tool. For more about its cut-to-size service, see the Right Foam home page. If the shape has cut-outs or angles, ask for a review before ordering so the quotation reflects the actual cuts.





Comments