top of page
Search

How to Measure a Tapered Cushion for Replacement Foam

1 day ago
2 min read

A tapered cushion is wider at one end than the other. That small difference matters: a single width and depth can produce a rectangular insert that will not follow the cover. Before requesting replacement foam, record the finished shape and say clearly which edge faces the front of the seat.

Tapered upholstery foam seat insert with a tape measure and paper template

Start with the cover and seating position

If you are reusing a cover, lay it flat without pulling the seams tight. Mark the front, back, left and right. If the old foam still fits reasonably well, use it as a cross-check, but remember that worn foam may have spread or lost thickness. Measure the usable space in the cover and the seat base as well as the old insert.

Measure both widths

Measure the front edge from one finished side seam to the other, then measure the back edge in the same way. Write them as separate numbers; do not average them. If the sides curve, mark where the straight taper ends and the curve begins. Check whether the left and right edges taper equally.

Record front-to-back depth and thickness

Measure the depth through the centre from front to back. If one side is longer because the back edge is angled, record both side lengths too. Measure the cover border or available seat space for thickness rather than relying only on a flattened old pad. State the unit for every dimension, such as centimetres, and keep all measurements in the same unit.

Draw the outline and check it

A top-down sketch is often clearer than a long description. Label the front and back widths, centre depth and thickness. Add rounded corners, notches, angled back edges or cut-outs where present. For an asymmetric cushion, label left and right as you face the seat; a mirrored outline may be wrong for the other side. A paper template can help you compare your sketch with the actual seat, but do not trim a cover or old foam merely to make the numbers look tidy.

Do not forget physical quantity

Write the number of separate foam pieces you need. For example: front width 58 cm, back width 50 cm, centre depth 52 cm, thickness 8 cm, quantity 2. This example describes two tapered pieces, not two price units. If the two seats are mirrored, say so and provide a sketch for each orientation.

When to ask us to check the drawing

Front and back width, depth and thickness may still be insufficient for a curved, notched or irregular seat. Send a clear photograph or labelled drawing showing every edge that affects the cut. Right Foam can review the specification before quoting; we should not guess missing geometry from a photo alone. Tell us if a tight existing cover must be reused.

For a measured replacement insert, see our replacement cushion foam.

If your piece is a straightforward rectangle, you can also get an instant quote using the finished dimensions and quantity. For a tapered shape, send the labelled drawing for review first.

 
 
 

Comments


bottom of page